Computer boots to black or blank screen with blinking cursor
When you boot a computer, and all it shows is a blackness or blank screen with a blinking cursor (information technology may await like an underscore), and so it means the BIOS or UEFI is attempting to boot from a source other than the hard bulldoze. The next step of the boot will only brainstorm when it finds the exact path from where it tin can kicking. In this post, nosotros will share what you can do to resolve this situation.
Reckoner boots to black or blank screen
If your Windows estimator restarts & boots to blackness/blank screen with a blinking cursor, it is usually because of conflicting boot devices. There are some piece of cake ways to prepare this problem, and the just time it will neglect when the source is decadent or not accessible.
- Remove unnecessary external devices
- Alter the social club of kicking source
- Change Hard Drive or Reinstall Windows.
Some of the resolution steps will need someone who understands computer BIOS and tin change a few settings. If you exercise non know, it is all-time to seek assistance to fix information technology.
1] Remove unnecessary external devices
If you accept a USB device that you had used to install Windows or perform a reset using a bootable device but had later formatted, then this could exist a problem. The BIOS is still looking into it.
Another set of situations is where you are trying to boot from a wrong USB bulldoze. It could be a similar-looking USB, juts not bootable. The second probability is the creation of bootable USB was not successful.
All you need to do for these scenarios is to remove the additional USB or Optical drive connection.
2] Change the club of boot source
Boot into BIOS, and alter the order of boot source from CD-ROM/Drive to HDD. The process of changing will differ from computer to reckoner, but here are the basic steps.
- Press F2/F10/Del key to boot into BIOS Settings
- Switch to Volume section
- Locate the section which defines the order of the boot
- Select HDD, and use Folio up or Page downwards to change the guild.
Related: Set Black Screen with cursor problem in Windows 11/10.
3] Change Hard Drive
If goose egg else works, then its probably the Difficult Drive. The BIOS is not able to find information from where it tin kick, and hence it keeps displaying the black/blank screen with a blinking cursor. To double-check the HDD condition, you can connect to another computer and attempt to kick from it. If it yet doesn't piece of work, and so you will have to reinstall Windows or fix the kick tape using the recovery method.
During the fix, if the recovery is not able to observe the hard drive, and then it's time to buy a new ane. We recommend you lot switch to SSD, which volition make the overall experience a lot faster.
We hope the methods were able to resolve the problem of bare or blinking cursor every time you boot your reckoner.
Post that may help yous if your calculator does not boot:
- Windows PC will not boot up or start
- Windows estimator unable to boot to BIOS
- Windows does non boot afterwards compressing System Bulldoze
- Windows computer won't boot after Organization Restore
- Windows Startup & Boot problems – Avant-garde Troubleshooting.
Source: https://www.thewindowsclub.com/computer-boots-to-black-or-blank-screen
Posted by: ferrellanown1990.blogspot.com
0 Response to "Computer boots to black or blank screen with blinking cursor"
Post a Comment